Air of Authority - A History of RAF Organisation
Mechanical Transport AP2782A (Section 27) - Photographic Vehicles
|
Brockhouse Mk 1, 4 wheel trailer, equipped as Type J photographic trailer |
|
| RAF Ref No | 16A/348 |
| General Information | |
| Chassis type | |
| Body | |
| Suspension, Wheels & Tyres | |
| Equipment | |
| Dimensions | Length - ; Width - ; Height - ; WB - ; G/C - ; TC - : |
| Weights | Unladen - ; Laden - : |
| Notes | |
|
Carrimore semi-trailer, 2 wheel, equipped as photographic vehicle |
|
| RAF Ref No | not stated |
| Notes | Details for these three vehicles were not included but were probably the same as those shown in AP2782, Group 4. |
|
Ford, 6x4, WOT 1A chassis, equipped for micro-filming |
|
| RAF Ref No | 16A/1232 |
| Engine | |
| Gearbox | |
| Performance | Max Speed - ; MPG - ; Radius of Action - |
| Dimensions | Length - ; Width - ; Height - ; G/C - ; TC |
| Weights | Unladen - ; Laden - : |
| Body | |
| Tyres | |
| Notes | |
|
Ford, 6x4, WOT 1A chassis, equipped as Type J photographic vehicle
Crown Copyright© |
|
| RAF Ref No | 16A/796 |
| Engine | Ford, petrol V8. Bore: 77.79 mm (3.0625 in), Stroke: 95.25 mm (3.75 in), Capacity: 3.62 litres (221 cu in), RAC rating - 30.01 hp. Max BHP - 60 at 2,840 rpm; Max torque - 1,800 lbs/ins at 2,000 rpm. |
| Transmission |
Clutch - Single dry plate Gearbox - 4 speed and 1 reverse. Ratios: 1st - 6.4 to 1, 2nd - 3.1 to 1, 3rd - 1.69 to 1, 4th - 1 to 1, reverse - 7.82 to 1: Front axle - 'H' Section. Rear axle - Full floating, spiral bevel drive, ratios 6.67 to 1. Overall ratios - 42.68 to 1, 20.6 to 11.27 to 1, 6.67 to 1, reverse - 52.16 to 1 |
| Performance | Max Speed - not stated; MPG - 8; Radius of Action - 125 miles |
| Dimensions | Length - 23 ft 9 in (internal - 154 ft 1½ in); Width - 7 ft 6 in (internal - 7 ft 0 in); Height - 11 ft 3 in (internal - 6 ft 6½ in); WB - 14 ft 8 in; BC - 3 ft 6¼ in; G/C - 9 in (centre axle); TC - 59 ft; Track - 5 ft 9 in (front), 5 ft 6 in (rear) |
| Weights | Laden - 6 tons 14 cwt. |
| Body |
Body - Van type, light section steel frame, double
panelled with sheet metal, fully insulated. Body divided
into two compartments by a partition incorporating a sliding door.
Forward compartment is a Film room and the rear compartment is a
Print room. Rear entrance door to body, detachable steps
stowed under body; escape hatch forward on nearside.
Ventilation flaps in sides of print room. Canvas awnings on
frames, hinged on each side of body at roof level, erected on struts
and enclosed by curtains and benches along the sides of the body
provide additional working space 15 ft x 5 ft floor space on each
side of the vehicle. When the tentage is dismantled, the
awnings and benches fold against the sides of the body, the curtains
are stowed in a bag and the struts are strapped along the sides of
the body. Equipment - The film room is equipped on the nearside with a cupboard and light proof service hatch and on the offside with a stainless steel sing, chemical storage cupboard and a 10 gallon water storage tank over the sink. The print room is equipped on the nearside with a film drying drum and a film viewer; two small compartments under a bench at the aft end house water pumping equipment, a temperature control tank for water and an electric radiator for temperature control of air to the film drying drum and in the body. A bench along the offside houses a refrigeration plant. The bench carries a print-glazing machine and a stainless steel sink. A domestic type electric water heater is mounted over the bench. Lighting and power, 230V is provided from the 6.3 kVA generating trailer. Cab - All enclosed type, seating driver and one passenger. Hip ring over passenger' seat. |
| Suspension | Front - Semi-elliptical , Rear - Inverted semi-elliptical trunnion mounted at centre |
| Brakes | Foot, mechanical on all wheels. Hand brake - mechanical on all wheels. |
| Wheels/Tyres | Dived type or 3-piece/10.50-16 singles on all wheels. |
|
Ford, 6x4, WOT 1A/1 chassis, equipped as Type J photographic vehicle
Crown Copyright© |
|
| RAF Ref No | 16A/809 |
| Notes | The specification is the same for the WOT 1A (16A/796) except that the foot brakes are Vacuum servo assisted on all wheels. |
|
Tasker semi-trailer, 8 ton, 2 wheel, drop frame, equipped as photographic vehicle
Crown Copyright© |
|
| RAF Ref No | Servicing, Type 'B' - 16A/1094 (Vehicle); 16A/1071 (Chassis); 16A/977 (Body): |
| General Information | |
| Chassis type | |
| Body | |
| Suspension, Wheels & Tyres | |
| Equipment | |
| Dimensions | Length - ; Width - ; Height - ; WB - ; G/C - ; TC - : |
| Weights | Unladen - ; Laden - : |
| Notes | |
|
Tasker semi-trailer, 7 ton, 2 wheel, drop frame, equipped as photographic vehicle
Crown Copyright© |
|
| RAF Ref No |
Multiprinting
Type 'B' - 16A/1092 (Vehicle); 16A/1071 (Chassis); 16A/975
(Body): Processing Type 'A' - 16A/524 (Vehicle); 16A/1071 (Chassis); 16A/972 (Body): |
| General Information | |
| Chassis type | |
| Body | |
| Suspension, Wheels & Tyres | |
| Equipment | |
| Dimensions | Length - ; Width - ; Height - ; WB - ; G/C - ; TC - : |
| Weights | Unladen - ; Laden - : |
| Notes | |
This page was last updated on 18/03/25©